Question

QF using the Agent just for Process no to Store

Updated October 9, 2018

asked on October 9, 2018

Hi i have a QF session in wich im using also the agent but 'just' to process the documents because i want to check the results before storing them. The source of the documents for the agent is a LF folder. The documents are being taken by the agent it reports that everything was ok but my source docs disapear and i dont know where they gone ..now i want to make the revision so what LF module i should use...¿?

Thanks for your help!

0 0

Replies

replied on October 9, 2018 • Show version history

If you use Quick Fields Agent just to process documents but not store them, then the documents will still be in Quick Fields, so you should see them if you open the Quick Fields Session that was used to process them.

As for where the source documents went, I would check how this option is configured in your session: https://www.laserfiche.com/support/webhelp/Laserfiche/10/en-us/administration/#../Subsystems/QuickFieldsAdmin/Content/Scan-Sources/Laserfiche-Capture-Engine-Post-Processing.htm

1 0

replied on October 9, 2018

Tessa, thanks for your answers. As you mention the documents were sent to the session in QF for revision.

0 0

replied on October 9, 2018

Tessa, do you know how can i refresh the revision pane in QF...¿? It just show the documents pending for revision only when i close and reopen the QF module.

0 0

replied on October 9, 2018

Quick Fields Agent can't use a session to run processing if you have that same session open in Quick Fields at the same time. You need to close and reopen.

1 0

You are not allowed to follow up in this post.

Question

Question

QF using the Agent just for Process no to Store

Replies

Sign in to reply to this post.